Messages

1

General Mach Discussion / Re: Ref Z-axis

« on: May 03, 2010, 05:42:20 PM »

Thanks for the help, with the RefAll button modified it works well. I only use the ref Z function because I want my torch in upper position when referencing the X and Y axis. During the cutting I want to use a THC from Campbell with a floating heat switch for the initial height.

Again thanks a lot for the reply's

Regards,

Remco

2

General Mach Discussion / Ref Z-axis

« on: May 02, 2010, 04:39:39 PM »

Hello,

I have a problem with referencing the z-axis of my plasma table. When I push the ref-all button the X and Y axis are referencing well, but the Z-axis does not move at all. When I push the ref-Z button in the settings screen it works well. Why does the Z-Axis not ref. with the ref-all command. Any help is welcome.

Regards,

Remco