Hello Guest it is March 28, 2024, 01:41:27 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Yianni - VJ - Glaux

Pages: 1 2 3 »
1
Finished Screens / Re: Mach3 2010 Screenset - Now available
« on: May 04, 2011, 09:40:37 PM »
+1

2
General Mach Discussion / Re: speech - waves?
« on: April 08, 2011, 11:12:27 PM »
Excellent advice !
Thank  you !

3
General Mach Discussion / Re: speech - waves?
« on: April 04, 2011, 09:26:15 PM »
Yeap, that did it,

Thank you very much Gerry ! !

4
General Mach Discussion / Re: speech - waves?
« on: April 04, 2011, 08:03:01 PM »
Gerry I followed your instructions to the letter but when I call the macro on MDI i get: scripter compile error...

Any idea what I m doing wrong?

5
General Mach Discussion / Re: speech - waves?
« on: April 04, 2011, 02:07:50 AM »
Allow wave files: Allows a macro to play a wave file for audible warning
Allow speech: Allows the speech synthesiser for initialisation and Help system messages


Yeah i got that far before I post, and I did search the forum for examples etc but no luck.
One of the machines I run does not have a relay to turn spindle off, It would be nice to have a notification sound to alert that milling is over.
How would one go to write a macro to play a Wav file ? 

6
General Mach Discussion / Re: speech - waves?
« on: April 04, 2011, 02:02:27 AM »
If fun consist of a few bottles of cheap wine, loud music, and good times....then no.
So by allow waves it doesn't  mean that surf 's up ?
What Am I gonna do now with all the surf gear I bought?

7
General Mach Discussion / speech - waves?
« on: April 04, 2011, 12:35:18 AM »
What about these do options on general config?
do they do anything fun?

8
Congrats Joakim !
It really is awesome !

Small question: I need to be able to step jog without pressing a safety button, I went through the manual but could not find how to do it, can you advise?

9
General Mach Discussion / Re: Merge G-codes ?
« on: March 18, 2011, 10:19:02 AM »
How do we do that? :)

No, seriously, am I the only one who sees the benefit from a utility that stitches separate G-codes in one?


10
General Mach Discussion / Merge G-codes ?
« on: March 17, 2011, 08:56:07 PM »
Hey guys,

Does anybody know of a utility that allows you to pick 2 or more G-codes and merge them into 1 ?

Pages: 1 2 3 »