1
General Mach Discussion / Re: Inconsistent feed speeds - any help?
« on: May 20, 2012, 05:38:16 PM »
Hood, thanks for the reply - here is a little more info...
I shut down the program per instruction after changing the backlash setting.
Just for grins, I rebooted the computer, and the problem disappeared. To confirm, I re-set the Z-Axis backlash to .012, shut down the program, restarted and ran a part - the problem reappeared.
I then reset the backlash to zero, restarted the program, and the problem was still present.
Then shut down the program, rebooted the computer, restarted the program and ran a part - problem gone. (phew!)
Did I just "not do it right" or might the xml file tell you something is amiss? If so, I can send it in the morning.
Thanks,
Steve
I shut down the program per instruction after changing the backlash setting.
Just for grins, I rebooted the computer, and the problem disappeared. To confirm, I re-set the Z-Axis backlash to .012, shut down the program, restarted and ran a part - the problem reappeared.
I then reset the backlash to zero, restarted the program, and the problem was still present.
Then shut down the program, rebooted the computer, restarted the program and ran a part - problem gone. (phew!)
Did I just "not do it right" or might the xml file tell you something is amiss? If so, I can send it in the morning.
Thanks,
Steve