Hello Guest it is September 29, 2020, 04:36:15 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - khootk

Pages: 1
1
Newfangled Solutions Mach3 Wizards / Re: Teach Wizard A Bit more
« on: January 14, 2006, 10:08:53 PM »
Hi Brian,
Very close to plasma user , the teach  wizard that seem step by step teaching by jogging X & Y to give co-ordinate and save  G-code.Here is some ideal may be friendly to plasma user with servo. Let say using cnc table with timing belt or gear rack, sharing servo encoder to read X & Y position but not by jogging. Just clamp a  2 mm pin to the (Z), manually turn the head down that will touch & guard the outline of the object to be copy. Before scanning Encoder supply must be ON & servo supply are OFF to avoid holding. To scan run teach wizard & move the X,Y axis alone to the outline of the object to be copy by handle and save G-code. does it possible ?

Thank you,
Khoo
 

Pages: 1