2
« on: April 14, 2010, 11:57:22 AM »
I have installed MACH 3 under XP Pro, and followed ZEN Toolworks setup, which indicates at the end, that I need to click on the RESET button and it will stop flashing. It does not. I have nothing in the parallel port. I reloade Mach 3, and without any settings I get same result. The Mach 3 manual indicates that maybe something else was in the parallel port that could have caused this. So I reloaded the system from the XP CD, and same results. So I though maybe the parallel port was the issue. So I used another computer, re-inited the disk, and reloaded XP on it. Then installed Mach 3 on it, with the exact same results. I can not get it to RESET. I did see in the Mach 3 manual, that you can click OFF LINE, and that does let it be reset. I assume that if it is in this state, that I cannot use the parallel port.
I do not think that I need a phone call at this point, if you can point me in the right direction. The driver board is due to arrive this week, so I will be able to plug the cable into the parallel port soon.
Any advice? What can I test? Thanks.......AJR