Hello Guest it is March 28, 2024, 02:10:31 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - JLClinehens

Pages: 1
1
General Mach Discussion / Re: Setting up axis home (Newbie)
« on: April 04, 2010, 12:36:59 AM »
I think a G28.1 needs tobe 0.000 because G28.1 means to find HOME 0.000 anything else, Z will HUNT for 0. On my cnc using Mach3 I know that for a fact

2
General Mach Discussion / Re: Setting up axis home (Newbie)
« on: April 03, 2010, 11:43:22 PM »
then what is the G-code for 1st Z move

3
General Mach Discussion / Re: Setting up axis home (Newbie)
« on: April 03, 2010, 11:41:47 PM »
what G-code are you using for home? G28 Z 0 or G28.1 Z 0 with zero set?

4
General Mach Discussion / Re: Setting up axis home (Newbie)
« on: April 03, 2010, 11:08:22 PM »
do you have a Z home limit switch? Are the units in/mm per turn set right

5
General Mach Discussion / Re: Setting up axis home (Newbie)
« on: April 03, 2010, 10:58:13 PM »
have you set the motor tunning for the Z axis?

6
having same problem, at first it would hit home switch, stop for a nano sec. then keep going, so reread manual, I had N.O. switches, manual calls for N.C., So I replaced them with N.C. Then it would hit home, then try to come off, and before it could move, the limit would trigger, so I disabled the limit, then it would hit home try to come off, and just keep going. Using G28.1 X 0 axes hits home and stops. Doesn't back off. Using  G28.1 x .500 axes rapid movement to .500 then creeps to home and stops, doesn't back off. Any help with this? Thanks, Jim

7
General Mach Discussion / Re: Software or Mechanical Problem
« on: April 02, 2010, 03:43:45 PM »
Great, That did it!!!!!   THANK YOU SOOOOOO MUCH!!!!!!!!!!!!!

8
General Mach Discussion / Re: Software or Mechanical Problem
« on: April 02, 2010, 03:30:25 PM »
went to operator, clicked on unlock, typed in password "None" and it still says LOCKED

9
General Mach Discussion / Re: Software or Mechanical Problem
« on: April 02, 2010, 03:28:45 PM »
went to add home switch, went to config.  flashing red light says configurstion locked out

10
General Mach Discussion / Re: Software or Mechanical Problem
« on: April 02, 2010, 03:15:46 PM »
help, some how locked myself out of config. how do you unlock?

Pages: 1