Hello Guest it is March 29, 2024, 01:16:21 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - csmoak25

Pages: 1
1
General Mach Discussion / Feed rate
« on: March 31, 2010, 03:20:38 PM »
I have my motor set to 50 IPM max and when I load a g-code it only runs at 6.00ipm, how do I change this? as you can tell by my question I am new to this any help would be greatly appreciated, my email is csmoak25@yahoo.com and thanks again

Pages: 1