Hello Guest it is August 08, 2020, 11:06:48 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - 88WILLY88

Pages: 1
1
General Mach Discussion / Re: digitize input to turn on an output Mach3
« on: January 20, 2019, 11:11:42 AM »
While waiting for your file I decided to delve into brains myself. I had some Boolean logic from school and the only difference between
yours and mine was you used a pass through and I used an immediate compare > 0. They both work fine. Thanks for inspiring me to
learn. 40 below C hear last night. Hope your in better weather. 

2
General Mach Discussion / Re: digitize input to turn on an output Mach3
« on: January 19, 2019, 12:53:57 PM »
I am using Port 2, Pin 11 for my probe input and would like to use Output 4 to drive the LED. Would there be much delay from contact to the LED coming on. I am using a PMDX-126 with USB smoothstepper. Thanks for your help.

3
General Mach Discussion / Re: digitize input to turn on an output Mach3
« on: January 19, 2019, 10:21:43 AM »
I was afraid there would be no easy way to do this. I even thought that some simple circuitry that's watching the input circuit could turn on the led but I'm not savvy enough to come up with that.

4
General Mach Discussion / digitize input to turn on an output Mach3
« on: January 18, 2019, 09:28:19 PM »
I am tired of having to look at the diagnostics screen to see if I have probe continuity before running auto zero. I did modify the screen to add a digitize led by the auto tool zero button. Still would like a LED at the router so I don't have to look at the computer at all. How would I configure the probe input to turn on an output that I could drive the LED with.

Pages: 1