Hello Guest it is March 28, 2024, 03:47:55 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Philip

Pages: 1 2 »
1
Hello been here before but I need help. I'm in the sign business using a cnc router. I'm sending my art from V carve pro to the mac 3 which the art is letters to be cut. When brought into the mac 3 preview window it shows the letters to be cut but also adds in these circles which are larger then the letters. Then we it loads and strat to cut it cut the first letters then starts cutting the circles. Does anyone have any thoughts.

thank you all.

2
Hello Dave:

Welcome and good luck. This is the place to be there are some very bright people lurking in these pages.

All the best,

Philip

3
General Mach Discussion / Re: Mach 3 stopped working
« on: March 23, 2010, 05:55:10 PM »
Hood:

I don't seem to have a restore settings. I'm going to try
to reset this the way you suggest.

Thank you so much for your help and time.

All the best,
Philip

4
General Mach Discussion / Re: Mach 3 stopped working
« on: March 23, 2010, 05:37:51 PM »
Hood thank you. I will give that a try. Is there a directory file that keeps back ups that I could pick a date when the machine
was running and use that as my new profile? If so where would it be cause I looked and nothing said back up that I could find.

Thanks for your time,
All the best,
Philip

5
General Mach Discussion / Re: Mach 3 stopped working
« on: March 23, 2010, 04:49:35 PM »
Hello Hood:

Here is the other one. Also I went into config/ports & pins/motoroutput and nothing was enable. I check the x,y,z,
and when back to the operating window and know the DRO changes value but it is not talking to the table.

Any ideas.

Thanks you
Philip

6
General Mach Discussion / Re: Mach 3 stopped working
« on: March 23, 2010, 03:37:31 PM »
Hello Hood:

Please see the attached. There was a .xml and one named router.xml and I think that would be the one.

Thank you for your time,
Philip

7
General Mach Discussion / Re: Mach 3 stopped working
« on: March 23, 2010, 03:17:34 PM »
Hood thank you, I will give it a try. Hope to send it soon.

Again thanks
Philip

8
General Mach Discussion / Re: Mach 3 stopped working
« on: March 23, 2010, 03:04:12 PM »
Hello Hood:

Sorry but what is XML. Please bare with me I not that up on this, I'm a sign maker.

Thanks for your help,
Philip

9
General Mach Discussion / Re: Mach 3 stopped working
« on: March 23, 2010, 01:13:03 PM »
Thank for the reply. Yes I have it turned on and nothing is happening.

10
Thank You
Philip

Pages: 1 2 »