Hello Guest it is March 29, 2024, 10:16:21 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - hamooteh

Pages: 1
1
hi
tha problem was solved, it was caused by a wrong parallel port number in the port and pins settings

thanks
mo

2
Graham
thanks for your replay, when i tested your code, again the xyz axis moves and the c b dosen't, but ii can see their axiss numbers moving in mack and the motors are dead.

thanks
mo

3
Hi all

I finally i got my system built . im working on a 5 axis cnc router. when i run my g codes mach shows all the axis moving fine on the diagnostic page. but when i run my motors i got only 3 motors spinning (the xy and z) my C B rotational axis are not moving. i have changed the pins and the other motor which was on the C and B was working ok , which means mach is not sending signals for the C and B . this is a sample copy of my g codes i set my (step per) for the rotation axis 4.4  200x8= 1600/360. im usin a DB25 brakoutboard

%
O0012
N5 G90 G40 G80 G17
N10 M6 T1
N15 M3 S1000
N20 G0 G90 G43 Z2.
N25 X-495.711 Y-826.236 C63.38 B-90.
N30 Z-133.311
N35 G1 X-488.559 Y-822.652 F200.
N40 Z-190.
N45 X-492.685 Y-814.419
N50 Z-133.311
N55 G93 F9999.9 B0.
N60 G94 X-474.299 Y-815.505 F200.


pleas help

thanks


Pages: 1