1
General Mach Discussion / Re: Gage Block Height increments oneself
« on: September 25, 2014, 03:36:35 AM »
Ok ... i found the problem myself.
I have conflicting OEM variables used in the range 1001 to 1009.
My variables monitors the micropump macro and modbus inputs via brains.
Gage Block Height use a OEM Variable 1001 and Digitizing Wizard use OEM variables 1002 to 1007 !
This isue is not documented in the manuals.
best regards
fridolin
I have conflicting OEM variables used in the range 1001 to 1009.
My variables monitors the micropump macro and modbus inputs via brains.
Gage Block Height use a OEM Variable 1001 and Digitizing Wizard use OEM variables 1002 to 1007 !
This isue is not documented in the manuals.
best regards
fridolin