1
General Mach Discussion / Tool offset problem
« on: March 05, 2010, 10:43:59 AM »
Hello All,
I am new to MACH3 but so far so good, I have 1 problem though with tool offsets. I set the tool diameters however the cut is not compensated for the tool diameter. I sure I am overlooking something as I am fairly new to CNC.
I am new to MACH3 but so far so good, I have 1 problem though with tool offsets. I set the tool diameters however the cut is not compensated for the tool diameter. I sure I am overlooking something as I am fairly new to CNC.