Hello Guest it is March 28, 2024, 05:15:07 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - woodenbug

Pages: 1 2 »
1
General Mach Discussion / Re: cannot reverse run from present feedhold
« on: February 25, 2010, 06:28:54 PM »
Thanks for all the help.
Woodenbug

2
General Mach Discussion / Re: cannot reverse run from present feedhold
« on: February 25, 2010, 04:23:02 PM »
Dog-gone it!
Thanks anyway.
Woodenbug

3
General Mach Discussion / Re: cannot reverse run from present feedhold
« on: February 25, 2010, 04:16:23 PM »
O K I went to resources and found this;
I/O Range DFOO-DF07
I/O Range DEOO-DE07
It is parallel port (LPT3)
Woodenbug

4
General Mach Discussion / Re: cannot reverse run from present feedhold
« on: February 25, 2010, 03:51:05 PM »
what should the address be?
Woodenbug

5
General Mach Discussion / Re: cannot reverse run from present feedhold
« on: February 25, 2010, 03:42:42 PM »
It is a pci card. Yes when I activated the switch last night they all went red.

6
General Mach Discussion / Re: cannot reverse run from present feedhold
« on: February 25, 2010, 03:35:07 PM »
I checked the limit switch and it is good. The settings seem to be correct all the port is 1 and the pin is 11.
Woodenbug

7
General Mach Discussion / Re: cannot reverse run from present feedhold
« on: February 25, 2010, 10:11:22 AM »
Thanks! :)

8
General Mach Discussion / Re: cannot reverse run from present feedhold
« on: February 25, 2010, 07:58:52 AM »
My brain finally clicked!
Thanks, Woodenbug

9
General Mach Discussion / Re: cannot reverse run from present feedhold
« on: February 24, 2010, 07:32:17 PM »
I cannot paste it here.

10
General Mach Discussion / Re: cannot reverse run from present feedhold
« on: February 24, 2010, 07:25:13 PM »
o k I found it! I will copy and paste.

Pages: 1 2 »