Hello Guest it is October 03, 2023, 07:40:28 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - jlmccuan

Pages: 1 2 »
SmoothStepper USB / ESS + MB3 Needed ASAP
« on: February 05, 2023, 02:05:44 PM »
I am at a client's shop and need an MB3 board as soon as possible. Are there any US based vendors that could deliver by Tuesday?

General Mach Discussion / Re: Mitsubishi AC Servo Spindle Retrofit
« on: April 05, 2022, 03:19:53 PM »
Thanks for the input.  I'll check out Delta.

General Mach Discussion / Mitsubishi AC Servo Spindle Retrofit
« on: April 03, 2022, 07:47:17 PM »
I have everything running on my retrofitted machine with Clear path motors, Mach3, an ESS with MB3, but now need to interface the Mitsubishi AC servo spindle motor with it's MBS-SVJ2-37 drive.  How can I connect the drive to Mach3 and maintain spindle orientation for tool changes? I have the specifications manual but it of course assumes you will use the Mitsubishi IO.

Any updates on this?  Did anyone get up and running?

Finished Plugins for Download / Re: A new Huanyang VFD plugin
« on: June 14, 2020, 05:00:03 PM »
My problem is, when I load mach3, I get an error saying that the plugin isn't configured.  When I try to change the port from 1 to 3, which is what the Device Manager shows, I get a popup screen that says 'Unable to Read Data" and the config port is changed back to 1.  Running XP

General Mach Discussion / Re: Mach Tool Change 5 Axis Screenset
« on: May 05, 2020, 01:03:30 PM »
I'm not too concerned with toolpath as I sim all my toolpaths after posting and before running anyway.

General Mach Discussion / Mach Tool Change 5 Axis Screenset
« on: May 04, 2020, 08:14:31 PM »
I need a ready to go, or good place to start, to have a 10 tool carousel, 5 axis screenset without all the fancy bright colors and blinking lights.  Any suggestions?

General Mach Discussion / MPG Flyout
« on: April 30, 2020, 01:25:35 PM »
Is there any way to make the MPG Flyout come up when Mach opens without having to hit the TAB key?

Mach Screens / Re: Mods to add Mist Coolant Button
« on: June 22, 2013, 01:33:32 PM »
Well, it "looks" like it worked.  Also did the same for the LED after finding the right number.  I did "save as" the screen and will copy it over to the control PC for testing.


Mach Screens / Re: Mods to add Mist Coolant Button
« on: June 22, 2013, 01:08:39 PM »
Oopps, I see now you are copying the Flood and changing it to Mist

Pages: 1 2 »