Hello Guest it is April 11, 2021, 06:53:56 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - gbjets

Pages: 1
1
General Mach Discussion / Re: please help Mach3 and Lazycam
« on: March 16, 2010, 09:14:49 PM »
If stepper, drop the velocity and acceleration in half and see how it goes. If ok, gradualy increase until the stepper jams / skips and back off by 30%.
RICH
We've tried many settings to no avail, we'll try so more.
Thanks.

2
General Mach Discussion / Re: please help Mach3 and Lazycam
« on: March 16, 2010, 08:30:54 PM »
Quote
when using lazycam to make pockets, the program stops randomly. I get the following error
Unrecoverable Error in EndGLdraw1....Notify artsoft

By program are you meaning in Lazycam or in Mach 3 Mill?
Can you post the dxf and tap file?

RICH
Thanks, we solved that problem, it was a bad parallel port card.  We still have the lost position problem.

3
General Mach Discussion / please help Mach3 and Lazycam
« on: February 17, 2010, 08:07:49 PM »
I just built gantry cnc router and am using mach3 with lazy cam.
I have 2 problems
1 the z axis motor jams at times causing it to lose it's reference to zero. It will also do it with the motor removed from the mill, turning with no load.
2 when using lazycam to make pockets, the program stops randomly. I get the following error
Unrecoverable Error in EndGLdraw1....Notify artsoft

I am new to this so any help is appreciated.

Pages: 1