Hello Guest it is March 28, 2024, 11:13:03 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - dnnsigns

Pages: 1
1
General Mach Discussion / Re: problem slaving X and A in Mach3
« on: February 25, 2010, 10:49:29 AM »
Thanks for your reply Hood I must have been typing my post at the same time as you.

Neil

2
General Mach Discussion / Re: problem slaving X and A in Mach3
« on: February 25, 2010, 10:47:42 AM »
Hi I have sorted it all working fine. For some reason one of the steppers was running in reverse giving the appearance of only 1 stepper running, changed direction and bingo.

Hope this may help someone.

Neil

3
General Mach Discussion / problem slaving X and A in Mach3
« on: February 25, 2010, 09:23:44 AM »
Hi can any one help please I am trying to slave A to X to drive the gantry, before slaving both steppers move independently, when I slave, A stops working help please.

4
Hi I am Neil I live in the UK we run a 10 year old Camtech Z7 8' x 4' router this has stopped working within the last couple of days and have made the decision to ditch the 10 year old controller and replace with new, and controll using Mach3. The forum is highly recommended as a good source of advice and help, I think I will need lot's of this as I am a Mach3 virgin.

Regards

Neil Herbert

Pages: 1