Hello Guest it is March 28, 2024, 09:31:11 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - ProboticsAmerica

Pages: 1
1
General Mach Discussion / Re: Mach memory cache annoyance
« on: February 10, 2010, 07:05:29 PM »
Thanks!  Sheesh, I can't count how many months I haven't used the edit code function because I didn't know that.  I only had the code window freak out on me as described by the other folks here once and it went away after a reboot and dump of that code file.

Now I just have to figure out how to prevent my machine from intermittently trying to force the entire spindle through the spoilboard.  Not a Mach3 issue - I suspect hardware.

2
General Mach Discussion / Re: Mach memory cache annoyance
« on: February 10, 2010, 01:59:14 PM »
This has been an issue for me for more than three years on a PC dedicated and connected to my router.  The PC runs nothing but licensed Mach3 v2.63(I think).  I seem to get edits in the body of the G-code, but if I add a line forget it.  You can open the files, close the files, rename the files, shut down Mach3, run CCleaner to get rid of all temp files, reboot the computer and sacrifice a goat but that line you added will never appear.  I always figured it was an amusing little Mach3 quirk.  

Pages: 1