Messages

1

General Mach Discussion / Re: new guy with 3axis CNC driver & Mach3

« on: February 06, 2010, 07:26:46 AM »

thanks a lot.

looks like that everything works for now.

thanks again and see ya

2

General Mach Discussion / Re: new guy with 3axis CNC driver & Mach3

« on: February 06, 2010, 06:56:11 AM »

thanks! it works perfect.

what about limit and home switches? they don't work for me at all...
just as i turn those limit, home and estop switches on in a Input signal bar, diagnostic bar shows that all of them are turned on, but they aren't even connected. active low is off..

3

General Mach Discussion / Re: new guy with 3axis CNC driver & Mach3

« on: February 06, 2010, 05:02:37 AM »

hope i did it right.. i'm using my own profile..not Mach3 Mill but My Mill, so i attached my mill xml file.

4

General Mach Discussion / Re: new guy with 3axis CNC driver & Mach3

« on: February 06, 2010, 04:44:22 AM »

yes, it does not turns on when g-code is runing, but if i turn it on with "active low" in config -> port and pins settings -> output signals, then it turns on.. but i need it not to be turned on with active low..

where can i get xml?

5

General Mach Discussion / new guy with 3axis CNC driver & Mach3

« on: February 06, 2010, 03:32:13 AM »

hi,

using win XP 32bit  default parallel port Mach3 Mill.
here is the thing..when i press Reset button on  a mach3 it turns motors on (it can run on g-code, and move about), but my mill relay output does not turns on. port is the same as motors pin is correct (when i turn it with Ative Low it turns it on..)
i went to diagnostics bar and when i push Reset it turns on the outputs of motors but Output #1 does not work..
also input switches does not work at all (autoset does not see them..).

i wonder maybe i have to install some kind off extra driver or some like that cuz' i don't think that it's the problem with port or pin settings..

Driver board from ebay..

sorry for my english.
thank you all.