1
LazyTurn / getting started with Lazy Turn
« on: March 30, 2010, 07:00:28 AM »
Hi everyone
I am new to mach 3. I am trying to use Lazy turn to generate Gcode to run a lathe. I can inport a GXF file select tool, generate a roughing cuts, finishing cut etc. but can not generate a G code listing at the end. when I select "post" a file is created but the file is blank. Please can someone tell me what I am doing wrong.
Steve
I am new to mach 3. I am trying to use Lazy turn to generate Gcode to run a lathe. I can inport a GXF file select tool, generate a roughing cuts, finishing cut etc. but can not generate a G code listing at the end. when I select "post" a file is created but the file is blank. Please can someone tell me what I am doing wrong.
Steve