Hello Guest it is March 28, 2024, 05:01:36 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - hardway

Pages: 1
1
I am using the wizard that comes with mach3. I have answered my own question. I needed to set a 'safe z' hight. is all good now, thanks anyway

2
Newfangled Solutions Mach3 Wizards / noob question using nesting
« on: March 09, 2010, 07:45:55 PM »
when the first program is finished (g54) and rapids to the start of the second part it does this at z0. is there a setting to change or do i have to manually change thees values every time? And when i stop a nested program say 2 or 3 parts in how do set the machine to ref. from the original ref. point  (g54) .
thanks in advance
Mike in West Bank.

3
General Mach Discussion / Re: oscillating tangential knife
« on: January 22, 2010, 04:36:09 PM »
I to need to make a tangential knife for my router maybe you could help me out as to where to start. Like some pictures so i can see what you have done?
 First question does it connect directly to your spindle and does the spindle handle the indexing?
 Second question is your knife a wheel like a pizza cutter?

Thankx in advance
Mike Scott

Pages: 1