Messages

1

General Mach Discussion / Re: Mach 3 and Linux

« on: January 07, 2010, 11:42:15 PM »

The only way I can see to get Mach3 to work in Linux is by using Wine or Crossover. I just installed Mach3 in Wine, but when I went to start the program it locked up and Crossover doesn't list Mach3 in its supported apps.

I suspect it won't work, but I could be wrong.

2

Mach4 General Discussion / Re: New people welcome !! Come in here and introduce your self!

« on: January 07, 2010, 11:06:50 PM »

Hey; I'm a newbie to both CNC and this forum. I'm CNCing a Proxxon mill, a Taig lathe, and a larger home made mill based on the Taig spindle. A long, long time ago in a Galaxy far far away I was a computer programmer using C, Pascal, Fortran and MS VB. Now I just sell and repair computers. Even with my experience with computers, the set up of Mach3, using the somewhat incomplete and cryptic install pdf, has been a bit frustrating.