Hello Guest it is December 07, 2023, 06:38:17 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - diamir

Pages: 1
1
General Mach Discussion / Re: verifyaxis macro only moves z-axis
« on: December 25, 2009, 04:41:44 AM »
I am using the actual Mach version with the Smothstepper. It seem to be the same fault, that Russ describes when simulating Mach3 without PP driver.
May be a macro with three "singleverify" commands for each axis will work. I will try this later, but I am not experienced in writing macros...

Regards

Tino

2
General Mach Discussion / Re: verifyaxis macro only moves z-axis
« on: December 24, 2009, 06:18:02 PM »
@ Ray:

Yes, I have home switches on all axis. Referencing is no problem.

Regards,

Diamir

3
SmoothStepper USB / Re: Smoothstepper and Joystick
« on: December 24, 2009, 05:44:19 PM »
Are there any news on using a standard gamepad with smoothstepper? I canĀ“t get mine to work at all.

Best regards,

Tino

4
General Mach Discussion / verifyaxis macro only moves z-axis
« on: December 24, 2009, 05:29:55 PM »
Hi!

When I execute the "verfiy position" macro (verifytest.m1s), only the z-axis is being verfied.

The code in the macro is as follows:

VerifyAxis  false

Any ideas?

best regards!

Diamir

Pages: 1