Hello Guest it is April 20, 2024, 02:08:51 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - dweber

Pages: 1
1
General Mach Discussion / Re: Set-up question -- output enable LED toggled
« on: December 21, 2009, 11:41:37 AM »
Hey, thanks for the response, Hood.

I actually managed to get my motors running last night -- the problem was in the breakout board wiring, not the software. So I should be up and running shortly :-)


2
General Mach Discussion / Set-up question -- output enable LED toggled
« on: December 20, 2009, 02:11:10 PM »
Hi Folks,

I'm just getting started in this so my apologies if this is in the wrong forum section.

I've just set up a 3-axis table and I'm having problems getting things up and running. Right now I think the source of the problem is that as soon and I hit the reset button in Mach 3 in the diagnostic page, the 1, 2, and 3 Enable LEDs in the "Output" section all toggle red. I'm not sure what's going on here. I've installed a port monitor software and the direction ports seem to work fine, but the step ports don't seem to modulate when I jog the tool.

Anyone have any insights on what might be going on here? Any information would be greatly greatly appreciated!

Thanks,

David

Pages: 1