Hello Guest it is January 22, 2022, 04:41:05 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - sbalder

Pages: 1
1
General Mach Discussion / Re: EMCO PC Mill and Turn 55 - Conversion
« on: February 11, 2011, 11:21:42 AM »
I see where you posted some information on the Emco thread over at the c-n-c zone.  Buried in that thread on page 10 is where we retrofitted a pc mill last year.  Honestly, it was one of the easiest retrofits we have ever done requiring only to drill out a few holes in the mounting plates and pulleys.  Here is the single-post link:

http://www.cnczone.com/forums/763694-post106.html

Pages: 1