Hello Guest it is April 09, 2020, 06:17:46 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - RonO

Pages: 1
1
General Mach Discussion / Re: Keyboard only use of Mach3 - possible?
« on: December 07, 2009, 08:18:55 AM »
How about a small keyboard with a built-in touchpad?

Ron

2
Video P*r*o*b*i*n*g / Re: g code from touch probe?
« on: December 06, 2009, 09:39:08 AM »
You could use a word processor.

Replace all the "-" with "X-"

Replace all the ",1" with "Y1"

Replace all the ",0" with "Z0"

Of course this only works if the first number for Y is different than the first for Z.

Ron

3
G-Code, CAD, and CAM discussions / Can I enter parameters at run time?
« on: December 02, 2009, 10:02:32 AM »
One of the neat things about TurboCNC is the programming extensions.

I have a few programs where I use ASK to enter information that adjusts the execution.

Is it possible to do something similar in Mach3? Perhaps using MDI?

Thanks.

Ron

Pages: 1