Hello Guest it is March 29, 2024, 04:49:01 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - bob0pedic

Pages: 1
1
General Mach Discussion / Re: Spindle wont start, keyboard jog doesnt work
« on: November 30, 2009, 09:05:19 AM »
I figured everything out.

It turns out, when you aren't provided with all of the machine's setup documentation, you have problems setting up the machine(!).

Thanks anyway.

2
General Mach Discussion / Spindle wont start, keyboard jog doesnt work
« on: November 25, 2009, 09:30:53 AM »
Hi all,

I'm running a Vortech Router with mach3 software. After using the support videos, I was able to solve most of my problems. I still have two left at this point in time:


The spindle won't start. I have tried to start it manually and with the S---- M03 code, and neither will fire it up. Otherwise, the machine works so far.

I cannot get the keyboard jog feature to work. This is more of a superficial issue, but I'd like to be able to jog the cutter with the keyboard as opposed to using the TAB-mouseclick-on-arrows method.

Any ideas?

Thanks.

Pages: 1