Hello Guest it is March 19, 2024, 02:49:16 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - fiend51

Pages: 1
1
so were do i buy  the relay at and how do i install it

2
would the  the gecko already have the relay in it ????

3
hi every one i have a taig cnc mill and a gecko 540 controller and i have a problem trying to run the  spindle ...i cant get it to turn on  the plug going to the motor is connected to the gecko control er  but i don't know how the to get it to run ...i went to mach 3 videos and watch them but i still cant get it to run is there...   every thing esle work great i  just don't know what i am doing wrong  please help if some one had the same problem 

4
General Mach Discussion / Re: mach 3 software problems or gecko problems
« on: November 18, 2009, 01:57:42 PM »
thank you i had to reinstall the software now it work great thank you again

5
General Mach Discussion / mach 3 software problems or gecko problems
« on: November 17, 2009, 10:36:51 PM »
hi  i went threw the video on how to install the software and every thing look fine but when you jog the  stepper motors  only the x axle works it goes only to the left but it doest not go back to the right  y axes works but it does not return back to home and the z does not work and a axes at all i thought i might be the program or the gecko 540 controller box  please help !!!!  and every thing i have is brand new ...

Pages: 1