1
dspMC/IP Motion Controller / Re: DSPMC loses connectivity after uprgading firmware - sort of
« on: April 04, 2016, 06:02:54 PM »
I'm using 32 bit XP. I fixed the blank config screen by reinstalling Mach3.
I did not make any network or other changes to the PC. I only upgraded the DSPMC's firmware.
The DSPMC is not visible to the PC (by any ping or ipscan method) until I cycle the power on the DSPMC after the PC has booted then it's fine. I'm working around it for now.
Thanks,
Dave
I did not make any network or other changes to the PC. I only upgraded the DSPMC's firmware.
The DSPMC is not visible to the PC (by any ping or ipscan method) until I cycle the power on the DSPMC after the PC has booted then it's fine. I'm working around it for now.
Thanks,
Dave