Hello Guest it is March 28, 2024, 08:24:09 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - KAW1428

Pages: 1
1
General Mach Discussion / C10 BOB parallel port problem
« on: November 07, 2009, 08:52:02 PM »
I have just purchased a 3 axis kit from Keling that included a C10 BOB and 5vdc power supply for the board.
When I connect the parallel port cable from my pc to the C10 the led on the board and power supply lights up.(Power to the control panel is off)
Has anyone else had this problem?
I should not that I am using Mach 3 and when the control panel is turned on the machine runs properly.

David

Pages: 1