Hello Guest it is May 19, 2024, 11:20:25 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - dgross

Pages: 1
Promote and discuss your product / Re: New Screenset for Mach3 Turn is here!
« on: September 15, 2019, 05:34:44 AM »
How do I get this new turn screenset?


General Mach Discussion / Mach3, Pokey757CNC LCD Display
« on: March 31, 2019, 09:19:12 AM »
I bought a Pokeys57CNC for my CNC lathe. So far everything works fine. I would like to install an additional LCD display to show the x and y positions. Unfortunately nothing is shown on the display. Can someone help me and explain what I am doing wrong or have forgotten?  Settings Pokeys, macropump, the two PWM signals...?
A LCD 4x20 is used, the display lights up.
Greeting Dietmar

Modbus / Altivar 12 Modbus TCP IP
« on: January 16, 2011, 02:03:37 PM »
Hello, it is possibly to control this Altivar 12 Speed Driver with Mach3 TCP IP. Speed and Direction?


Modbus / Enable Signal and Modbus TCP IP
« on: April 19, 2010, 06:27:40 AM »

I would like to use the enable signals 1-4 of Mach 3 for the controller enable of my positioning controllers. But not via the parallel interface, instead with a Wago module via TCP IP. Is it only possible to realize this with Brains or VB or is it also possible to use “Ports and Pins” with “Port 0”? If I realize this with Brains, which settings do I have to make under “Ports and Pins”?

Pages: 1