Hello Guest it is March 28, 2024, 04:50:11 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - PETSATCOM

Pages: 1
1
Galil / Re: Mach3 + Galil
« on: April 18, 2010, 12:14:08 PM »
Question on Servo Amps and Motion Control Boards

Are the AC servo drives PWM by the servo analogue input +-10V DC.

They say the Motion Control Board puts out a standard +-10V.  Is it a pulse train or a continuous signal?
That is the servo drive take input of +- 10V and outputs what?  PWM to the motor?  vs a continuous output?

I have a motion control card MPU 11 from Ajax out puting +- 10V
I can get a copley servo amp for example, and drive a AC servo motor or DC servo motor.
Just want to understand what the +- 10V drives in terms of servo amp output.

Want to make sure the Motion Control Board, Servo Amp and Motors are compatible.

jim

2
Galil / Re: Mach3 + Galil
« on: April 16, 2010, 09:22:08 PM »
anyone have a block diagram on the hook up of Mach 3 the motion control board, servo amps, encoder feedback for a complete system that works

jim

3
General Mach Discussion / Re: Mach 3 and Galil Motion Control boards
« on: October 31, 2009, 05:04:00 PM »
Does anyone have an ICD on MACH 3.  What is the output thats drives servo amps. In the case of a Galil board I guess its software to the Galil that is converted to Galil language for Galil to turn into a servo amp drive voltage.

anyway a nice ICD would explain all.  Does one exists.

Jim P  (Petsatcom)

Pages: 1