Hello Guest it is August 06, 2020, 03:15:36 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - artecnc

Pages: 1
1
General Mach Discussion / Re: Alphacam
« on: February 04, 2010, 03:24:25 PM »
Thank you very much
I wiil see that...and you can see my site
 www.artecnc.com.ar...and now I began to do some parts for rc model cars.
Best regards
Antonio

2
General Mach Discussion / Alphacam
« on: February 04, 2010, 10:56:44 AM »
Hi
I read that I can use Fanuc post, when y load the file in the Mach3, dont see a toolpath¿?...is that correct? I´m used to Syil 4Plus Mill.
Thank in advance
Antonio

Pages: 1