Hello Guest it is March 29, 2024, 02:00:23 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - HansD

Pages: 1
1
FAQs / Re: Y axis moves randomly if keybord arrow pressed
« on: August 31, 2014, 04:12:17 PM »
I solved it - there was a faulty motor connector.
It sometimes made contact and sometime it did not - causing the strange behavior.

2
FAQs / Y axis moves randomly if keybord arrow pressed
« on: April 14, 2014, 03:39:11 PM »
I have mach3 running for 3 years with no problems - until now:

when I want to move the Y axis (left or right) with the keybord (arrow up/down) it moves randomly in a direction.
The same when I use the home button on the mach screen it moves randomly in a direction mostly the wrong one.
when I press the same keybord arrow twice (or more) the Y axis moves randomly

I checked the hardware, limiting switches, cables, connectors, even swapped the geco motor drives - no luck

Any idea how to check if mach3 is causing it

Hans

Pages: 1