Hello Guest it is November 12, 2019, 08:42:17 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - rf44420

Pages: 1
1
CVI MachStdMill (MSM) / Re: Parallel Port2 no Led activity
« on: October 27, 2010, 06:10:39 PM »
Dave

Second PP was enabled and working fine, however pins 2-9 was not checked.  Checking pins 2-9 did bring PP2 LED's to life but I won't be able to use it that way with my setup. 

Thanks,  Ron

2
CVI MachStdMill (MSM) / Parallel Port2 no Led activity
« on: October 27, 2010, 04:39:37 PM »
Hi Dave,

I have 3 inputs and 4 outputs on PP 2, all are working fine.  On the Hardware page – PP Driver Tab all are grayed out.
 
PP1 has activity but bit 14 (output) is on all the time.  This is a drive enable bit and toggles on / off on the Hardware Signals Tab.

version R3.043.022  - 0.4.3(beta12)

Ron

Pages: 1