Hello Guest it is November 29, 2021, 03:01:14 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Carlosf71

Pages: 1
1
General Mach Discussion / Re: X axis stopped working
« on: February 06, 2010, 01:21:00 PM »
Port 1   0x378                  

Motor Output                     
   Enabled   Step   Dir   Dir Low   Step Low   Step Port    Dir Port
X axis   Yes   14   4   x   x   1   1
Yaxis   Yes   2   17   x   x   1   1
A axis   Yes   3   8   x   x   1   1
B axis   Yes   5   9   x   x   1   1

Inputs                     
Estop   Yes   Port 1   Pin 10    Act LOW         

Output Signals                     
Enable    Port   Pin               
1   1   1               
2   1   7               
3   1   6                           
4   1   6                           

                                 
            
                                 

2
General Mach Discussion / X axis stopped working
« on: February 06, 2010, 01:14:02 PM »
I have been running Mach3 with Dell 800 for 3 months on a 4 axis machine. The X axis stopped working suddenly.

I have checked the LPT port motor output pins for voltage. Y, A, and B look the same. DIR 0-5V, Step 0-50mV. Y, A, and B work. X stopped working. DIR shows 0-5 v Step shows 80mv -130mv at the port pin. DRO moves but no motor movement.

I have verified the X axis wiring and motor are good on the other axis.

I have check the LPT port with a printer and it works.

The strange thing is if I swap the Step and Dir pins in the setup I get good voltage readings. (but my driver board can't use it like that).

Thoughts appreciated.

(I would like to get some sleep.)
Thanks

 



3
General Mach Discussion / Re: Does demo Mach 3 do pwm output?
« on: October 19, 2009, 04:22:49 PM »
Ray,

Would you care to share how you use the pwm to control hot wire heat? I have a controller board without documentation. I have managed to get everything working but the pwm output.

Thanks,

4
General Mach Discussion / Does demo Mach 3 do pwm output?
« on: October 17, 2009, 05:28:23 PM »
I am unable to see the pwm out of the demo Mach 3. I am about to purchase Mach 3 but I would like to know that it will output pwm for heat control of a hot wire.

Regards,

5
Hi,

I'm new to Mach 3 and cnc in general. I'm building a CNC foam cutter.

Does the demo Mach 3 software output pwm? I have tried to set it up but don't see it. Everything else (motors, etc) are working great.

Regards,


Pages: 1