Hello Guest it is November 13, 2019, 05:03:23 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - _DK_

Pages: 1
G-Code, CAD, and CAM discussions / Can Mach3 use G43?
« on: October 14, 2009, 01:51:56 PM »
Sorry if its a silly question... I'm helping a friend with some programs... I use a cam system here at work and I posted some programs out for him to try using my generic Fanuc post. Everything seems to work OK, but I would like to incorperate tool changes, even if they are manual.
Does Mach3 support tool offsets using the G43 along with the H#

M3T6 (msg,3/16"ball)

H6 being a record in an offset table like on a Fanuc 18m control?

Pages: 1