Hello Guest it is November 29, 2020, 08:30:50 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - melv

Pages: 1
1
General Mach Discussion / Re: Spindle Speeds x3cnc
« on: October 21, 2009, 09:57:20 AM »
Hi Ray thank you for your help it is really appreciated.
Melv.

2
General Mach Discussion / Re: Spindle Speeds x3cnc
« on: October 19, 2009, 05:50:20 AM »
Good Morning Ray,
There seems to be no backup with these cnc machines, are you able to recommend a board ect that could cure the problem ?
Best Regards,
Melv.

3
General Mach Discussion / Re: Spindle Speeds x3cnc
« on: October 10, 2009, 07:31:05 AM »
Hi Ray,
As I am not conversant with electronics's will you please explane to me what marginal hardware Is ?
It has been suggested to me at our model club that I fit a smooth stepper willthis help or cure the problem ?,
If you have any suggestions (not rude) I will listen and absorb your comments.
My B est Regards,
Melv.

4
General Mach Discussion / Re: Spindle Speeds x3cnc
« on: October 10, 2009, 05:25:19 AM »
Hi
I would like to say thank you for your quick reply & I will follow your advice.
MY BEST REGARDS,
Melv.

5
General Mach Discussion / Spindle Speeds x3cnc
« on: October 09, 2009, 04:04:05 PM »
 Hi this is my first question on the forum,
When I put 700rpm spindle speed into Mach3 the machine only returns 400rpm at the spindle,
At 3,000rpm + the spindle speeds are o.k.
The motor does not start untill you have put 700rpm in to Mach3,
Machine is a KX3 CNC MILL
ANY INFORMATION WILL HELP PLEASE.
Melv.

Pages: 1