1
FAQs / Set up G-code step unit question. (Newbie)
« on: October 07, 2009, 10:42:12 AM »
My imported g code keeps coming up much larger than my DRO capacities.
Can I change the DRO display to inches/mm's ?
Max travel (shorth of home/limits)
X = 78" (48.000 DRO display)
Y = 25" (6.81 DRO display)
I convert CAD DXF's to G- Code using Cut 2D using the inch designation. The program loads but doing a test run causes
the axis to go beyond the DRO display considerably.
I know I missed a basic step some where in the set up. Can anyone help? At least point me in the correct area of the forum
to search for the answer?
Mike
Can I change the DRO display to inches/mm's ?
Max travel (shorth of home/limits)
X = 78" (48.000 DRO display)
Y = 25" (6.81 DRO display)
I convert CAD DXF's to G- Code using Cut 2D using the inch designation. The program loads but doing a test run causes
the axis to go beyond the DRO display considerably.
I know I missed a basic step some where in the set up. Can anyone help? At least point me in the correct area of the forum
to search for the answer?
Mike