Hello Guest it is November 21, 2019, 08:58:35 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - prontow

Pages: 1
1
General Mach Discussion / G83 will rapid out but not in, Mach3Turn
« on: November 05, 2010, 03:29:34 PM »
I am using several G83 peck drilling routines in Mach3 Turn. The drilling cycle works but it will rapid all the way out and it will not rapid back in. Takes up a lot of time. I tried G83.1 and it worked exactly the same as G83.
Am I missing something?
And I am a bad boy, I am at work without the Mach3Turn revision I am running. I know this will be a question.

Pages: 1