Messages

1

General Mach Discussion / VB macro & shuttle.

« on: September 30, 2009, 03:55:22 AM »

Hello everyone

I am moving the lathe in using MACH3.
This is a question of the VBmacro & shuttle.


I want to make the chamfering of the lathe in using the jog dial of the shuttle.
How can I move the tool by VBMacro ,for direction 45degrees by synchronizing with the jog dial?

2

General Mach Discussion / Re: for using 'CustomMacro1~10'

« on: September 30, 2009, 03:36:18 AM »

Hi !  Ray L.

It went well. Thank you.

3

General Mach Discussion / Re: for using 'CustomMacro1~10'

« on: September 30, 2009, 02:32:42 AM »

Thank you for a prompt explanation.

Was it M code number?
I will try it.

4

General Mach Discussion / for using 'CustomMacro1~10'

« on: September 29, 2009, 08:34:09 PM »

Hello everyone!

Please teach the method of using'CustomMacro1~10'.

What kind of number should be written on the 'CustomMacro1'BOX of Dialog on config shuttle.