Messages

1

Works in progress / Re: Flash RU Screen

« on: May 31, 2010, 08:38:54 PM »

Hi Pablo

Very nice screen you made. Really like the look of it, and the "pop-up" keys....
 nice!
Looks just like the touchscreen that i have always wanted for my machine )
I'll test it as soon as I get my touchscreen hooked up to my router

I think if you continue the development, there will be a lot of new testers!

Keep up the good work!

Best regards
Borge
Denmark

2

General Mach Discussion / Re: Self Aligning Gantry

« on: November 17, 2009, 04:00:27 AM »

hi Soundman

Did you fix the problem? I'm having the same issue here.
I tryed to uncheck "Home Salve with Master axis" but then everything goes wrong here
Not sure what my next move will be

Borge

3

General Mach Discussion / Re: Mach3 4.0 Rev Update

« on: July 28, 2009, 04:05:57 PM »

Hi

Any update on the 4.0 ver ?

Regards
Borge

4

General Mach Discussion / Re: Gantry Squaring Setup/Help

« on: June 30, 2009, 08:05:53 PM »

Hi

Did you remember to check the function "Home Slave with Master Axis" found in the:

Config -> general config menu ?

Regards
Borge

5

General Mach Discussion / X-axis with 2 steppers ?

« on: April 25, 2009, 04:24:19 PM »

Hi

I'm about to set up a system with 2 steppers on the X-axis
How do I do that ?
And is it possible to home the two steppers seperate (incase lost steps on one of them)?

Thanks
Borge

6

General Mach Discussion / How do i setup Mach3 to control a laser with TTL input?

« on: March 20, 2009, 08:50:59 PM »

HI

I'll like to be able to control a small laser diode on my router via Mach3
For engraving letters on balsawood

I have seen some laser controllers that use TTL input on Ebay

How do I setup Mach3 to turn on/off the laser at the right moment?
As i understand it there is a small startup time for the laser before it's ready to "burn"
Is it possible to let Mach3 handle it all, or do i need to change something in my postprocessor aswell?

regards Borge

7

General Mach Discussion / 1280x1024 screen for Marc3 ?

« on: January 01, 2006, 10:03:13 PM »

HI
And thanks for a great forum. just build my first mill, (the second is on it's way) 

I was wondering if it was possible to get marc3 to fit a screen size 1280 x 1024 because
that's the size i normally use ?

Some time ago i saw a screen layout with some nice looking "digital" numbers on it
Anybody have a suggestion where i can download a screen like that, or some thing like that ?

Best regards

Borge
Denmark