Hello Guest it is March 29, 2024, 05:14:57 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Syl

Pages: 1
1
General Mach Discussion / Re: MPG - BUTTON
« on: October 15, 2009, 12:57:33 AM »
this is a test.

2
General Mach Discussion / Re: Rosequist mill and Mach3
« on: September 08, 2009, 08:14:25 PM »
Hi -

Does anyone have an Mach3 xml file for the Chinese mill/drill converted to CNC by Chris Rosequist?

Sure would appreciate it!

thanx . . . syl

3
General Mach Discussion / Re: Rosequist mill and Mach3
« on: September 08, 2009, 07:48:26 PM »
Thanx.  I solve the problem by loading 1.84 instead of 3.04.  I don't know what the difference is, but I can now reset. 

Now I need an xml file.  I'll try to make one., but I'm not too optimistic about that.

Thanx again . . . syl


4
General Mach Discussion / Rosequist mill and Mach3
« on: September 08, 2009, 02:24:22 PM »
I have  a Chris Rosechrist CNC mill made from a modified Chinese mill/drill.  Works fine.

Have been away from milling for a couple of years, and now want to get started with Mach3.  But I'm having trouble getting it going.

Does anyone have a xml file for the above machine?  Right now my license is from Mach one and I don't know if I need a  new one.  Comments?

Also I cannot get Mach3 to reset even though I have unplugged the parallel cable.  More comments?

thanx . . . syl

5
Hi -

My name is Syl and I live in Hillsborough, Ca. - near San Francisco. I'm 84 years old  - but still have my marbles even though my bod is letting me down!

I'm not new to Mach, but new to this forum.  I mess around with CNC doing hobby stuff - like model engines, telescopes and other stuff.

I have a Sharp copy of a Hardinge lathe and a Chris Rosechrist CNC mill made from a modified Chinese mill/drill.  Works fine.

Have been away from milling for a couple of years, and now want to get started with Mach3.  But I'm having trouble getting it going.

Does anyone have a xml file for the above machine?  Right now my license is from Mach one and I don't know if I need a  new one.  Comments?

Also I cannot get Mach3 to reset even though I have unplugged the parallel cable.  More comments?

thanx . . . syl

Pages: 1