Hello Guest it is August 08, 2020, 03:12:36 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - morgan

Pages: 1
1
General Mach Discussion / Re: history errors
« on: September 01, 2009, 04:13:25 PM »
Ger21 thanks I changed the setting of the iJ mode and it works great  your a life saver

thanks again

2
General Mach Discussion / Re: history errors
« on: August 31, 2009, 11:02:54 PM »
thanks ger21 I'll give it a try tomorrow 

3
General Mach Discussion / history errors
« on: August 31, 2009, 09:37:35 PM »
 I keep getting an error that says    "  Radius to end of arc differs from radius to start of line "
I'm using vectrics Aspire and Vectrics pro 6 and both get the same error is there a setting in Mach 2/3 that might have got changed ?

Pages: 1