1
CS-Lab / Re: CSMIO-S Rigid Tap Cycle Runs on Program Load
« on: November 29, 2015, 06:36:41 PM »
I had overlooked that. I knew it had to be something simple.
I have considered modifying the M84 code to turn on a bit that would disable the brake when running and turn it off at the end of the M84.
I was also going to look at the firmware changes to see if that was addressed.
Thanks again
I have considered modifying the M84 code to turn on a bit that would disable the brake when running and turn it off at the end of the M84.
I was also going to look at the firmware changes to see if that was addressed.
Thanks again