Hello Guest it is March 28, 2024, 05:57:06 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - b_delerious

Pages: 1
1
Newfangled Solutions Mach3 Wizards / Re: Circular pocket problems
« on: August 29, 2009, 11:14:29 AM »
I've upgraded to the newer version, but the problem is still there.

Though the problem only seems to arise at certain % step-overs. %40 and %50 both seem alright.

-bri

2
Newfangled Solutions Mach3 Wizards / Re: Circular pocket problems
« on: August 27, 2009, 09:39:26 PM »
Simple 3/4" pocket at 0,0. Using a 1/4" tool.

Using newest Mach Version R3.042.029, but was having similar problems with older versions.

-bri

3
Newfangled Solutions Mach3 Wizards / Circular pocket problems
« on: August 27, 2009, 04:19:35 PM »
I've come across a small problem with the circular pocket wizard. When generating the wizard and previewing, everything looks fine. When posting, the G-code changes slightly, causing an "uneven" spiral. Attached image captures show the problem. The unevenness causes chip load to vary.

Suggestions?

-brian

Pages: 1