1
General Mach Discussion / Plasma equipment
« on: August 19, 2009, 08:19:31 AM »
Hello,
I have plasma equipment - there are three 2-phase stepping motors (for X, Y, Z) and three controllers Leadshine M542 stepping driver (http://www.leadshine.com/2-4-54.html) connected to PC via Parallel port (LPT).
For this plasma equipment now I am using CNC Command 'n Cut software (www.trackercnc.com), there are bad software.
Support of Leadshine M542 controller say me, that I can try using your Mach3 software.
Can you provide me information how I can setup Mach3 for plasma equipment, after demo version will successfully then will purchase license.
Thanks.
I have plasma equipment - there are three 2-phase stepping motors (for X, Y, Z) and three controllers Leadshine M542 stepping driver (http://www.leadshine.com/2-4-54.html) connected to PC via Parallel port (LPT).
For this plasma equipment now I am using CNC Command 'n Cut software (www.trackercnc.com), there are bad software.
Support of Leadshine M542 controller say me, that I can try using your Mach3 software.
Can you provide me information how I can setup Mach3 for plasma equipment, after demo version will successfully then will purchase license.
Thanks.