Hello Guest it is March 28, 2024, 11:33:29 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - baker519

Pages: 1
1
General Mach Discussion / Re: Z axis retract
« on: August 16, 2009, 02:05:07 AM »
Yes, I found it in the cam program. It was in a setup tab that I never used.
Thank you for the help

2
General Mach Discussion / Z axis retract
« on: August 15, 2009, 05:36:21 AM »
I have a small cnc router and after I home 0,0,0  and start a program the z axis retracts to 0.7874 and when the program is finished it retracts to the same 0.7874. This is not a problem until I use a long tool, or thick work piece thern the z axis runs to the end of the screw  and stalls. How do you change the retract value?

Pages: 1