Hello Guest it is March 28, 2024, 05:34:02 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - rodhead

Pages: 1
1
General Mach Discussion / Re: router drive bars
« on: December 20, 2009, 08:37:27 AM »
Hello

do you know of a good 3 axis controller that isn't very expensive to use? I was going to use cw230 controller they about $50.00 each. One of them is bad and the company I got it from is out of stock. any suggestions?   thanks for your help

2
General Mach Discussion / Re: router drive bars
« on: December 18, 2009, 05:36:40 PM »
I'm using nema 23 277 oz. would I need a reduction?

3
General Mach Discussion / router drive bars
« on: December 18, 2009, 09:56:33 AM »
Hello I have my cnc router built. I'm deciding on if I should have the xyz bars turned down and use a drive belt, or should i attach them straight to the nema motor shaft's. I use mach 3 software. any help is highly appricated. thanks and Merry Christmas to all

4
General Mach Discussion / Re: NEED HELP WIRING
« on: August 22, 2009, 08:51:36 AM »
it is a Single output 24 volt DC  at 6.5 amps, Input voltages 100-120, and 200-240 volts AC.   

5
General Mach Discussion / NEED HELP WIRING
« on: August 21, 2009, 07:46:40 PM »
HERE IS WHAT I HAVE AND I CAN'T FIGURE IT OUT> PLEASE HELP ME WIRE THESE.

6
General Mach Discussion / Re: cnc driver board
« on: August 15, 2009, 10:56:22 AM »
Is the G251 only for one motor?

7
General Mach Discussion / Re: cnc driver board
« on: August 15, 2009, 10:53:21 AM »
The voltage is 3.6 v. and 4 phase 3.0A. they have 6 wires.

8
General Mach Discussion / cnc driver board
« on: August 14, 2009, 06:52:24 PM »
Hello

 I have my cnc router almost finished. I'm using mach 3. I have nema 23 277oz motors. can anyone tell me a goo 3 axis board and power supply for these? Thank you in advance

9
General Mach Discussion / road runner
« on: August 14, 2009, 02:02:57 PM »
Hello

 I'm very new with mach 3. I have the full version and I am trying to find the road runner file. can anyone help me with this?  Thanks in advance.

Pages: 1