1
General Mach Discussion / Re: mach 3 set up w/ a 3 AXIS CNC DRIVER BOARD problems.
« on: August 08, 2009, 11:57:08 PM »
I should have posted my solution when i got it here.
theres a output option, with 'enable' settings. set these to 8 9 and 14 to enable each axis. make sure step and dir is set. double check your port number. use the arrow keys and you should get results.
all 3 axis are turning, both directions, and i'm currently in frame development phase w/ the machine itself now.
theres a output option, with 'enable' settings. set these to 8 9 and 14 to enable each axis. make sure step and dir is set. double check your port number. use the arrow keys and you should get results.
all 3 axis are turning, both directions, and i'm currently in frame development phase w/ the machine itself now.