Messages

1

General Mach Discussion / Re: Tool path display

« on: July 28, 2011, 11:08:23 AM »

Thanks again Hood, yes that's what I meant, oh well I will have to live with the tool display as is.

2

General Mach Discussion / Re: Tool path display

« on: July 28, 2011, 09:47:12 AM »

Hi Hood and thanks for the quick reply. Does that mean even the screensets created would need to conform to this rule? Thanks again 

3

General Mach Discussion / Tool path display

« on: July 28, 2011, 09:28:50 AM »

Hi everyone, after searching the forum I am bewildered that I can not find any reference in being able to rotate the tool path display window so it correspondences to my table. On all screens the tool display screen seems to show the x, y & z axis in the bottom left hand corner with the y being the vertical. I would like to have the axis symbol up in the left hand top corner with the x axis arrow being vertical & pointing down, any help for a very tired & sore eyed member please? 

4

Mach3 under Vista / Re: Vista and Mach3 Demo problems

« on: July 03, 2010, 08:51:32 PM »

Thanks Muchly Jerry.

Regards Trudy from Down Under
 

5

Mach3 under Vista / Re: Vista and Mach3 Demo problems

« on: July 03, 2010, 07:14:57 AM »

Hi there, does anyone know if it is ok to to load mach 3 on top of the demo or should the demo be removed. Thanks

6

General Mach Discussion / Re: Bad Character

« on: May 27, 2010, 06:57:04 PM »

Thanks evryone. Much appreciated.

Tinker

7

General Mach Discussion / Re: Bad Character

« on: May 26, 2010, 07:18:38 AM »

These are the g-codes that came with the demo program. All three are the same

8

General Mach Discussion / Re: Bad Character

« on: May 26, 2010, 07:16:31 AM »

999
dxflib 2.0.4 8
0
SECTION
2
HEADER
9
$ACADVER
1

9

General Mach Discussion / Bad Character

« on: May 26, 2010, 06:47:20 AM »

Hi all. I am a newbie and am just settting up my cnc with the mach 3 demo. I keep getting a bad character usedline 0 message. Can anyone help please.